FREQUENTLY ASKED QUESTIONS
Q: Can I reclaim the screens?
A: Yes, in fact because there is no glue involved, you can reclaim many times without having cleaning chemicals deteriorate glues, releasing the mesh from the frame.
Q: Can I remove an exposed panel and re-install for a re-print?
A: Yes, single color designs and multi color prints without crucial line butt registration can now be removed and re-installed into the frame for reprints without distorting and losing tension.
Q: Are custom sizes available?
A: Yes, lead times and minimum order requirements apply, please contact PanelFRAME or your Dealer for details.
Q: When I attempt to tension the mesh, the trac bar tends to roll up instead of sliding into position?
A: There is very little tolerance for friction, the cause of this happening is because there is some dirt, dust or grime on the frame. Simply wipe down the the frame surface with a damp cloth or a small amount of WD40 to insure the extrusion surface is free from dust. This will stop the "rolling" and allow the trac bar to slide.
Q: How much tension should I expect?
A: The tension of the mesh varies from size and mesh count. Our panels are specially constructed and continually tested and checked during all phases of manufacturing. Our panels average approximately 25 newtons when installed.
Q: Can I reclaim the screens?
A: Yes, in fact because there is no glue involved, you can reclaim many times without having cleaning chemicals deteriorate glues, releasing the mesh from the frame.
Q: Can I remove an exposed panel and re-install for a re-print?
A: Yes, single color designs and multi color prints without crucial line butt registration can now be removed and re-installed into the frame for reprints without distorting and losing tension.
Q: Are custom sizes available?
A: Yes, lead times and minimum order requirements apply, please contact PanelFRAME or your Dealer for details.
Q: When I attempt to tension the mesh, the trac bar tends to roll up instead of sliding into position?
A: There is very little tolerance for friction, the cause of this happening is because there is some dirt, dust or grime on the frame. Simply wipe down the the frame surface with a damp cloth or a small amount of WD40 to insure the extrusion surface is free from dust. This will stop the "rolling" and allow the trac bar to slide.
Q: How much tension should I expect?
A: The tension of the mesh varies from size and mesh count. Our panels are specially constructed and continually tested and checked during all phases of manufacturing. Our panels average approximately 25 newtons when installed.
